Iron sliding bolt for doors. Traditional model 1800 – 1900s.

Hand forged bolt, long model for external doors. Used for double doors where one door leaf is intended to be fixed and the other openable. Common model from the end of the 18th century to the middle of the 19th century. Long sliding bolt is mounted at the top of the door and short at the bottom. Can be used both as surface-mounted or recessed fittings. Supplied together with a closing plate for the door frame.

Interior door lock intended for room doors after the middle of the 19th century, when there was a transition from surface-mounted chamber locks to recessed so-called mortise locks. The lock is a 3-keeper lock with 44 different key combinations and can be locked from both the outside and the inside. The lock has recess dimensions according to older standards. Therefore, it is often suitable from the late 1800s onwards. This lock is suitable for our prints and knobs, as well as accessories in the form of key plates, rosettes, long plates, etc.

Lock body and lock plate in galvanized steel. Supplied with two keys and strike plate. The latch bolt is reversible when dismantled, i.e. a right-hand lock can be turned into a left-hand lock and vice versa. Counter plate included. Equal locking with the same key for several locks can be specially ordered. Thorn depth 4.5cm.

Please note that the dimensional sketch is mirrored in relation to the product image.

Counter chest for chamber lock of 18th century type. Normally associated with double doors, so-called deadbolt doors. The counter chest is mounted on the fixed door leaf, and the lock itself is mounted on the wicket door. Can sometimes also be mounted on single doors. In this case, the counter chest is mounted on the door frame itself.