Interior door lock intended for room doors after the middle of the 19th century, when there was a transition from surface-mounted chamber locks to recessed so-called mortise locks. The lock is a 3-keeper lock with 44 different key combinations and can be locked from both the outside and inside.
The lock has recess dimensions according to older standards. Therefore, it is often suitable from the late 1800s onwards. For this lock, our prints and knobs fit, as well as accessories in the form of key plates, rosettes, long plates, etc.
Lock body and lock plate in galvanized steel. Supplied with two keys and strike plate. The latch bolt is reversible when dismantled, i.e. a right-hand lock can be turned into a left-hand lock and vice versa. Counter plate included. Equal locking with the same key for several locks can be specially ordered. Pin depth 4.5 cm
EUR170.81
The locks are relatively similar throughout the ages. Most commonly, they were used in combination with a deadbolt or padlock on outbuilding and shed doors.
EUR29.61
Strong, wide, hand-forged lock spring for chamber locks and other locks from before the middle of the 19th century.
EUR23.69
Lock spring for chamber lock of turn of the century type 1900. Fits normal lock chests. Depending on the lock model, the spring may need to be bent or cut. Length 4.5 cm, width 6 mm
EUR9.11
Hand-forged marlin. Linseed oil fired iron. 45 mm.
EUR4.10
Hand-forged marlin.
Linseed oil fired iron. Length 60mm.
EUR4.56
Hand-forged bolt, short model for external doors. Used for double doors where one door leaf is intended to be fixed and the other openable. Common model from the end of the 18th century to the middle of the 19th century. Long sliding bolt is mounted at the top of the door and short at the bottom. Can be used both as surface-mounted or recessed fittings. Supplied together with a closing plate for the door frame.
EUR90.64
Iron sliding bolt for doors. Traditional model 1800 – 1900s.
EUR12.66
EUR11.75
Hand forged bolt, long model for external doors. Used for double doors where one door leaf is intended to be fixed and the other openable. Common model from the end of the 18th century to the middle of the 19th century. Long sliding bolt is mounted at the top of the door and short at the bottom. Can be used both as surface-mounted or recessed fittings. Supplied together with a closing plate for the door frame.
EUR99.75
The toilet hasp is the classic closure of a toilet door. Until the turn of the century 1900, when people still lived with outhouses, the hasps were usually made of iron. Then came brass hasps and eventually the pushes in combination with a locking function, such as “occupied-unoccupied”. If you want to have the same kind of print throughout the home, i.e. also on the toilet door, the lock hasp is still the best solution, as it can be used independently of other door fittings.Gysinge’s toilet hasp is a handmade product and completely according to an original from around 1900.
Sand cast by hand in brass. Therefore, unevenness in the casting may occur (unlike machine-made brass parts). Gysinge brass fittings are not lacquered, i.e. they darken and age in a traditional way.
EUR35.98
Spare part for the following knobs and levers in our range.
3031-182 Door knob brass
3031-183 Brass door handle
3031-184 Door knob iron
3031-194 Post horn ironing
EUR3.19
Angle strike plate for 18th century type chamber locks. Available in several designs that fit our different variants of 18th century chamber locks.
EUR72.42
